This is a current, but partial, list of error messages which the logger can produce. There are some messages which can not appear under normal operating conditions relevant to OEM users, and for the sake of simplicity these have not been included.
Each message begins with Ennnn, where nnnn is a 4-digit decimal number, padded with leading zeroes if necessary. The number allows host software to interpret the error code as desired if the rather terse messages from the logger are unsuitable for any reason.
Note that some messages may be followed by variable elements not shown here.
Command interpreter errors
E0100 unknown error
E0101 command parser busy
E0102 invalid command
E0103 protected command, use 'permit'
E0104 feature not yet implemented
E0105 command prohibited while logging
E0107 expected argument missing
E0108 invalid argument to command:
E0109 feature not available
E0110 buffer full
E0111 command failed
E0112 expected data missing
E0113 invalid data
E0114 feature not supported by hardware
Data memory errors
E0300 unknown error
E0301 memory erase not completed
Scheduling errors
E0400 unknown error
E0401 (W) estimated memory usage exceeds capacity
E0402 memory not empty, erase first
E0403 end time must be after start time
E0404 end time must be after current time
E0405 failed to enable for logging
E0406 (W) not logging
E0408 (W) logging already active
E0409 uncleared error, use 'errorlog'
E0410 no sampling channels active
E0411 period not valid for selected mode
E0412 burst parameters inconsistent
E0413 period too short for serial streaming
E0414 thresholding interval not valid
E0415 more than one gating condition is enabled
E0416 wrong regimes settings
E0417 no gating allowed with regimes mode
E0418 cast detection needs pressure/depth channel
E0419 calibration coefficients are missing
E0420 required channel is turned off
E0421 raw output format not allowed
E0422 AUX1 not available in current serial mode
Configuration errors
E0500 unknown error
E0501 item is not configured
E0502 configuration failed
E0505 no channels configured
E0506 can not create calibration entry
E0509 feature not available on this channel
Calibration errors
E0600 unknown error
E0601 no calibration for channel